The Parts of the Club Head
The head of the golf club has several parts: the hosel, where the head connects to the shaft; the face, which actually strikes the ball; the sole, which is the part closest to the ground; and the back, which is on the side opposite the face. We've talked a bit about the design of the back, and there's not much to say about the hosel, so let's look at the face and the sole.
|
The Face
When you hear an announcer for a golf tournament talking about the player's selection of a club, you'll generally hear whether the player has chosen a wood or an iron, and then a number. The number is related to the angle at which the face slopes back from vertical when the club is held in its normal position facing the ball. A higher number for the club represents a greater degree of slope away from vertical, generally resulting in a higher, shorter shot. There are some slight variations between manufacturers, but the club numbers and their related slopes generally look like this.
The slope is important for two reasons. First, the face will launch the ball on a path perpendicular to the plane of the face at impact, so a more "laid back" face will start the ball on a higher trajectory. This is crucial when a golfer tries to send the ball over some obstacle, or when the golfer wants the ball to come back down at a steep angle, which tends to result in a shorter roll after landing. The second important aspect of the slope is spin -- the greater the slope, the greater the spin.
A spinning golf ball is a good thing because the rapid spin provides aerodynamic lift, causing a spinning ball to travel higher and farther than one with no spin at all. The spinning ball is also less influenced by small gusts of wind, making for a more predictable shot. One of the other features you will notice on the face of a golf club, the grooves, also help provide spin.
The grooves on the face of a golf club serve two purposes. First, they provide just a bit of "bite" for the golf ball as it's sliding up the face, helping it to spin more rapidly. Next, if grass is trapped between the ball and club at impact, the water in the grass will be squeezed out by the nearly 3,000 pounds of force generated by the average swing. Like the tread on an automobile tire, the grooves on the club face give the water somewhere to go so that the ball doesn't skid up the face without spinning.
The Sole
Ideally, the sole of the golf club will minimize the twisting of a bad hit. In woods, the broad, flat sole with rounded edges helps the head glide over the surface of the grass without digging in. Shots using irons tend to take patches of the turf away (the patch is called a divot), so the sole of irons are designed to slice through the turf evenly, without twisting or unexpected tugging to disrupt the golfer's shot.
The Most Important Part: The Golfer
Mark Twain called the game of golf "a good walk spoiled." Golf club designers have tried to make it more difficult for golfers to spoil their fine walks with bad shots. Many golfers say the new forgiving clubs make a huge difference in their game. Variations are available for all levels of strength and experience, but choosing the right club and using it well are up to the golfer.
A poor choice of club and a bad swing can still produce the worst of shots from the best of clubs. And that's a good thing because it means the quality of the golfer is still of some importance in the game of golf.
No comments:
Post a Comment